The Dry-Brik contained in the Dry & Store family of products has three important functions: (1) to permanently remove the moisture molecules that are released from the devices during the warm drying cycle; (2) to drive the relative humidity inside the box to a much lower level than is possible with just a heater, thus maximizing the drying capability; and (3) to capture odors. Boxes using heat alone lower the relative humidity by warming the air, but the amount of moisture in the air does not change. While warm air can hold more moisture than cool air, unless the water is removed, it can condense right back where it was when the heat goes off. That's where the desiccant comes in. Products without a desiccant might work fine in a desert, but in a humid environment they are simply ineffective. The Dry & Store family of products uses Dry-MaxTM technology: a controlled amount of warm dry air, a soft but continuous flow of air around all of the small ports and openings in an electronic device like a hearing instrument, and the powerful Dry-Brik II desiccant to do the job right! IMPORTANT: The new version does not have copper strip on top for older Professional units with serial numbers prior to DSG119426. No briks with the copper strips available on this listing. According to the Manufacturer they have an insert available that will allow you to use these Briks in your older unit. The manufacturer-Ear Technology, will send an insert to you free of charge.
- Please note that this is for TWO 3-packs of Dry-Briks
- The Dry Briks will work in the Dry and Store Zephyr, Global, and Professional units.
- The Dry-Brik II comes with new consumer-friendly packaging for easy storage. The Dry-Brik II has a two-month life expectancy, even under the most humid conditions.
- IMPORTANT: New version does not have copper strip on top for older Professional units with serial numbers prior to DSG119426.